# ethtool eth0

Settings for eth0:

Supported ports: [ TP MII ]

Supported link modes: 10baseT/Half 10baseT/Full

100baseT/Half 100baseT/Full

Supports auto-negotiation: Yes

Advertised link modes: 10baseT/Half 10baseT/Full

100baseT/Half 100baseT/Full

Advertised auto-negotiation: Yes

Speed: 100Mb/s

Duplex: Full

Port: MII

PHYAD: 1

Transceiver: internal

Auto-negotiation: on

Supports Wake-on: pumbg

Wake-on: g [ 提示: g 表示已啟動. d 表示禁用 ]

Current message level: 0×00000001 (1)

Link detected: yes

Settings for eth0:

Cannot get device settings: Operation not permitted

Cannot get wake-on-lan settings: Operation not permitted

Current message level: 0×000000ff (255)

Cannot get link status: Operation not permitted

eth0 Link encap:Ethernet HWaddr 00:16:k5:64:A9:68 [ Mac地址 ]

inet addr:192.168.6.56 Bcast:192.168.6.255 Mask:255.255.255.0

inet6 addr: fe80::216:17ff:fe6b:289/64 Scope:Link

UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1

RX packets:3179855 errors:0 dropped:0 overruns:0 frame:0

TX packets:2170162 errors:0 dropped:0 overruns:0 carrier:0

collisions:0 txqueuelen:1000

RX bytes:3832534893 (3.5 GB) TX bytes:390304845 (372.2 MB)

Interrupt:17